SKIPPER INTERNAL HULLS GREY ENAMEL SINGLE COMP. FOR BILGES 2.5LT

Product specifically formulated for applications inside boats for the protection of wood, iron and fiberglass surfaces. It is a quick-drying paint with excellent resistance to sea water, oils and fuels in general. Its use is recommended for bilges, engine rooms and boat floors. It is recommended to apply at least two coats of product. Available in white and gray.

SUPPORT PREPARATION AND APPLICATION CYCLE

New iron. The support must be clean, dry, degreased, free from rust or traces of calamine and pre-treated with a coat of suitable anti-rust such as EVIOX CROMOMINIO. Then apply 2 coats of INTERNO SCAFI grey or white enamel, 18-24 hours apart.

New wood. The wood must be clean, dry and seasoned and treated if necessary with a coat of EVIOX CROMOMINIO diluted at 30-40%. After 12-24 hours apply two coats of INTERNO SCAFI grey or white enamel, 18-24 hours apart.

Already painted surfaces:
-If the old paints no longer offer adequate adhesion to the substrate or are brittle, they must be removed mechanically. Clean the surface thoroughly and then follow the instructions above for new substrates.
-If the painted surface is in good adhesion condition and it is only necessary to restore the finishing coats because they are dirty or dulled by time, clean and degrease the surface well and sand with medium-fine sandpaper. Remove dust and sanding residues and apply 2 coats of INTERNO SCAFI grey or white enamel, 18-24 hours apart.

Application Brush roller and spray

Brush-roller dilution 5-10%

Thinner 400Spray dilution10-30%

Thinner 900

Dust-free drying 2 hours (20C)

Overcoating time 18-24 hours (20°c)

Application temperature Between +10 c and +40 c

Relative humidity Less than 80%

Recommended dry thickness 40-50 microns per coat

Theoretical yield m2/litre10/12